Microsoft Exchange 2013 – Alternative Port

Important Points

  • These instructions assume you have already setup your AuthSMTP send connector in Exchange 2013 using the instructions on the Exchange 2013 setup page
  • By default Exchange 2013 will attempt to connect to the AuthSMTP servers on the default SMTP port 25, if you wish to change this to one of the Alternative ports (2525, 587) you will need to take the following steps

 

Step One

  • Open the ‘Exchange Management Shell

   

Step Two

  • Type the following command to get a list of all your send connectors:Get-SendConnector

Step Three

  • To change the SMTP port for your connector you will need to enter the following commandSet-SendConnector -Identity “AuthSMTP Connector” -Port 2525

Step Four

  • To confirm the change has been accepted you can enter the following commandGet-SendConnector “AuthSMTP Connector”|fl Port

Step Five

  • You should now be able to send messages via AuthSMTP on the alternative port 2525

 

5,167 total views, 12 views today

1 thought on “Microsoft Exchange 2013 – Alternative Port

Leave a Reply

Your email address will not be published.